1 of   Under which of the following circumstances should an EPE be performed in the State of Texas?
2 of   FDA Form 2579 should be completed under which of the following circumstances?
3 of   You are working on a Midmark M11 (new Style). What is the expected voltage reading between the right side of R32 and U12 pin 8 (+/- 10%) during pressure calibration?
4 of   You are troubleshooting a Tuttnauer 2540EKA. The unit successfully passes the first full cycle but overheats every other cycle until the unit cools. Which component could the cause of the symptom?
5 of   You are troubleshooting a Tech West Rocky Series Compressor. The pressure falls below 80 PSI but the heads do not turn on. You find proper voltage going to the heads. What component could cause this symptom?
6 of   You install a pressure switch on an Air Star 22, turn the unit on, watch the gauge increase until the unit turns off as expected. You verify that air is present in all rooms. Later in the day, a staff member from that office returns from lunch and calls to complain that the compressor will not turn on. What could be causing this?
7 of   You are on the phone with a customer troubleshooting a 220V Golden Vac with a symptom of no vacuum. The unit is running but vacuum is not produced. What additional information is useful for drilling down to the root cause?
8 of   You are troubleshooting a vacuum system with a low suction symptom. The unit is running but low vacuum is produced throughout the entire office. What additional information is useful for drilling down to the root cause?
9 of   You are working on a Marus Delivery System and notice the slow speed is leaking water at the handpiece. What is your course of action?
10 of A combo valve is:
11 of You are working on a Tuttnauer EZ10. The safety valve is popping and the temperature is at 164F. What could cause the issue?
12 of Why does Tuttnauer include the Air Jet Valve on all models of autoclaves?
13 of The number one reason a Tuttnauer autoclave will fail a spores test is:
14 of Which of the following are indicators of a failing door gasket on an autoclave?
15 of You are working on a Tuttnauer 2540M and notice a slow water drip from the condensation coil. Which of the below statement(s) is/are correct?
16 of Dental X-Ray Machines in Texas are Regulated by what code?
17 of The State of Texas requires technique charts for x-rays to be displayed next to the x-ray control except in which situation?
18 of When the air button, and only the air button, is pressed on a DCI Quick-Clean syringe yet the customer complains of a quick buff of water, which component is most likely to be failing?
of Which statement is a line from the movie Forrest Gump?
You made the cut.
We are interested in meeting with you. If you would like us to contact you please complete the form below. Good Job!
You did not make the cut.
You were very close. Give it another try. Score more than a 70% on this test and we will be interested in meeting with you.
You did not make the cut.
Score more than a 70% on this test and we will be interested in meeting with you.